Performance and Analysis of Methylammonium Lead Bromide (MAPbBr₃) Solar Cell
Ashfaq Nabi
MS Student, Department of U.S Pakistan Center for Advanced Studies in Energy, University of Engineering and Technology Peshawar, Pakistan
Mehmood Ullah Shah
MS Student, Department of U.S Pakistan Center for Advanced Studies in Energy, University of Engineering and Technology Peshawar, Pakistan
Keywords: Wide-band-gap perovskites, Methylammonium lead bromide (MAPbBr₃), Perovskite solar cells, Niobium pentoxide (Nb₂O₅), Cuprous oxide (Cu₂O), OghmaNano simulation, Electron transport layer, Hole transport layer, Power conversion efficiency (PCE), Numerical device optimization
Abstract
Wide-band-gap perovskites such as methylammonium lead bromide (MAPbBr₃) are attractive for semi-transparent, and indoor photovoltaics because of their high open-circuit voltage and good stability. In this work, an all-inorganic planar FTO/Nb₂O₅/MAPbBr₃/Cu₂O/Au solar cell was designed and numerically simulated using OghmaNano, which solves the Poisson and drift-diffusion equations with Shockley-Read-Hall recombination. The effects of absorber thickness, electron transport layer (ETL) and hole transport layer (HTL) thickness, absorber and transport-layer doping, absorber defect density, and operating temperature on the current density-voltage characteristics and quantum efficiency were systematically investigated. The optimized device used a 600 nm absorber, a 170 nm Nb₂O₅ ETL, and a 110 nm Cu₂O HTL, with doping concentrations of 1×10²⁰ m⁻³ (absorber), 1×10²¹ m⁻³ (ETL), and 1×10²⁴ m⁻³ (HTL), a defect density of 1×10¹⁹ m⁻³, and an operational temperature of 300 K. Under AM 1.5G irradiance, this device attained a PCE efficiency of 10.29%, an open-circuit voltage of 1.62 V, a short-circuit current density of 10.39 mA/cm², and a FF of 61%. These results show that Nb₂O₅ and Cu₂O are promising inorganic transport layers for efficient and stable wide-band-gap perovskite solar cells.
